• Design Studio
• Polymer Molding
• Batteries & Packs
• Battery Chargers
• Power Supplies
• DCDC Converters
• Automotive
• CCTV / Security
• Inverters
• Frequency Converters
• Custom Products
• Technical Resources
• Surplus
• Consulting
• Blog
• Power Humor
• About Us
• Policies
• Site Map
• Our EU Branch
• View Cart

Replacement power supply for Polaroid FLM1507

Custom design and manufacture of state-of-the-art battery chargers, UPS, and power supplies for OEMs in a hurry!

	Qty 1-10
PST-YD100W	$29.50

Part Number	PST-AC0407
Parameter
Output	12 volts, 15 volts, 16 volts, 18 volts, 19 volts, 20 volts or 21 volts, single output, user adjustable
Output Power	100 Watts or less
Input Voltage	100-240 VAC, 47-63 Hz
Input Frequency	50/60 Hz
Excelent efficiency	85% at half load 82% at full load
No load overhead	600 mW 12 volt setting 1.5W 24 volt setting
Temperature	0° to 40° C Operating, overtemperature cutout is reset by removing and reapplying AC power.
Overcurrent Protection	See table below for current cutout values at each voltage setting. Overcurrent protection is "hiccough mode" which automatically restarts when the overload is removed.
Size	120mm x 70mm x 50mm (4.75 x 2.75 x 2 inches)
Agency Approvals	CE, double insulated
Output Connectors Included	6.3 (O.D) x 3.0 (I.D) x 11(L) mm 5.5 (O.D) x 2.5 (I.D) x 11 (L) mm 5.0 (O.D) x 2.1 (I.D) x 11 (L) mm 4.75 (O.D) x 1.7 (I.D) x 11 (L) mm Y EIAJ 6.5 (O.D) x 4.3 (I.D) x 11 (L) x 1.4 (PIN) mm
How Many Amps are Too Many?	In a regulated power supply, such as these switchmode power supplies, amps don't matter as long as you have enough. Excess amperage is just held in reserve. An anology is "doubling the size of your water heater won't make your shower pressure change." Unregulated power supplies (such as wall-mount transformers) are different, since they are built to supply a specific voltage at a specific amperage. If you draw less amperage the voltage will go up. In conclusion, a higher current rating won't hurt your appliance as long it is a regulated power supply. For unregulated power supplies the specification should be close to the original.