|
Custom design and manufacture of state-of-the-art battery chargers, UPS, and power supplies for
OEMs in a hurry?
This is a
microprocessor controlled DC/DC converter which can be used as a DC input charger or solar charge controller Nickel-Cadmium,
and Nickel metal hydride batteries. It also has serial communications and is programmable with great flexibility.
 Can
be used as a solar charge controller for a a range of cell counts and battery capacity.
Can use locally to
the battery to boost voltage after a long wire run, for example on POE.
Output voltage can
be higher or lower than the input voltage.
State-of-the-art
charging algorithms for nickel metal hydride and nickel cadmium batteries.
Also useful in
other energy harvesting applications since it can be programmed to use whatever power is available, unlike other battery
charging circuits.
| Quantity |
1-49 pieces |
50-99 |
100-199 |
200+ |
| PST-SEP10-NiMH |
$80.00
 |
$75.00 |
$63.30 |
$61.00 |
| Input voltage |
8-30 volts, 16V nominal |
| Battery pack size: |
8 cells, 9 cells, 10 cells, self adjusting |
| Output Current |
2 amps nominal |
| Termination method |
-deltaV |
| Dead-pack charging |
Trickle charge always available to "jump start" dead packs |
| Form |
Circuit board product, (frame or case developed on request) |
| Dimensions |
4" x 1.8" x 0.5" (10 cm x 4.6 cm x 2 cm) |
| Mounting Diagram |
Dimensioned mounting diagram |
| Weight |
1.2 oz, 34 grams |
| Connector |
Pin out |
| J3 |
Pin1 Negative out
Pin2 Positive out to battery
Pin3 N/C
Pin4 negative to green LED (needs a 1K
resistor)
Pin5 negative to yellow LED (needs a 1K resistor in series)
Pin6 negative to red LED (ditto) Pin7 +5V for LED
return |
| J4 |
Pin1 RX
Pin2 TX |
| J5 |
Pin 1 MCLR
Pin 2 VDD
Pin 3 NEG
Pin 4 DAT 5 CLK |
Click on the diagram for a readable flow chart
|
